What is wallpaper or laminate first

Repair implies the high-quality performance of finishing work to eliminate the deficiencies of the premises that were identified during operation. Performing repairs is not an easy task. In addition to accurate planning, a number of other questions arise, such as: what used to be wallpaper or laminate.

Repairs

Wallpaper refers to the building and finishing material for facing walls and ceilings in the room. It is sold in the form of a rolled web in a roll, the width of which is 53, 75, 106 cm, and the length is 10 or 25 m. By type, they are divided into: paper, vinyl and non-woven.

Under a laminate is meant a floor covering, the basis of which is a high-density fiberboard. The top layer consists of a decorative and protective wear-resistant film.

Wallpapering and laying the laminate implies that all the preparatory work of the surfaces has been done:

1. They do work on leveling the floor (rough and finish screed);
2. Work was done to align the walls (plastering, puttying the walls);
3. The room is clean and dry.

Important: Preparatory work on the surfaces is carried out at the final stage of repair, i.e. after completed redevelopment, window installation, installation or replacement of a heating system, etc.

Before laying the floor covering, all preparatory work on preparing the floor surface must be performed. Laminate is not placed on a bare concrete floor; a backing must be laid (cork backing, foamed polyethylene, polystyrene foam, etc.). Joints of substrates must be fixed with tape.

The technology of laying perpendicular to the window opening will help to hide the seams of the joints of the laminated coating. Also, when laying, you must leave a gap of 1 cm between the wall and the extreme adjacent board. Use wedges (special rails) to set a fixed clearance.

Laminate boards are fastened together using wedge locks or glue. The gaps of the laminate boards are removed with a block and a hammer. After laying the last row, the wedges are removed.

Sticking, regardless of the type of wallpaper is performed as follows:

1. Before gluing, treat the walls with a primer and allow to dry;
2. For the first sheet on the wall, using the leveling level, find the vertical and mark it;
3. Cut the sheets, adding a couple of centimeters to the length;
4. Prepare a glue solution;
5. Apply glue on the wall or on a sheet of wallpaper;
6. Proceed to sticking;

Pokleyka of modern wallpaper occurs joint to joint.

In accordance with building codes and rules for the decoration of the premises are performed from top to bottom. And also, when choosing the right method, it is necessary to be guided by the degree of dust formation and the amount of garbage from the process. Also, the sequence of work should be selected on the basis of the greatest to least likelihood of damage to the previous work.

Of the above requirements, the choice of priority finishing will fall on the laying of flooring. Installation of the laminate eliminates the possibility of damage to the walls, unlike other floor coverings, which require adjustment in places of contact with the walls.

Another argument is that the laminate is sensitive to high humidity. Wallpapering procedure should take place indoors without drafts. Also, the room must be closed until the wallpaper glue has completely dried. During this period, the greenhouse effect is formed in the room. Thus, the structure of the laminate can be disrupted, which adversely affect the operational properties.

When performing wallpapering, there is a high probability of staining the laminate. Therefore, when performing the initial repair in the room, it is first necessary to glue the wallpaper, and then lay the laminate.

There are no prohibitions, but only recommendations on the sequence of gluing or laying. Moreover, the laid life of the laminate exceeds several times the period of use of wallpaper. The service life of some types of laminate reaches 25 years. In any case, the next time you change the design of the room, you will have to change the wallpaper when the flooring is laid.

To ensure the integrity of the flooring when gluing wallpaper, you must use a plastic film or other flooring that can protect the flooring.

Reference: Monitor film integrity to avoid damage and contamination of the laminate. Use stepladders and other construction equipment with rubberized smooth legs.

In any case, changing the interior by replacing the wallpaper will be cheaper and more expedient than replacing the laminat. But at the same time, carefully carry out preparatory work to protect the laminate. Protect the floor from water.

After gluing the wallpaper, it is necessary to let them dry, while covering the floor with a film. Then, after the glue has completely dried, do not forget to ventilate the room - this will help get rid of excess moisture.

Most repair professionals will advise you to glue the wallpaper first, and then lay the laminate. In this case, no one will forbid you to make repairs in the reverse order.