A water cooler is an indispensable equipment not only in office buildings, but also at home. It is acquired when around the clock it is necessary to have purified water in hand in hot and cold form. But sometimes even this, at first glance, simple equipment, can fail.
A very common breakdown is a situation in which the cooler stops heating water. That is why today we decided to talk about this particular malfunction, and to find out whether it is possible to eliminate it on our own.
The main reasons that the cooler does not heat water
Why doesn't the cooler heat water? In fact, there are several reasons why the equipment may stop working. These include:
- The device is disconnected from the network;
- The socket, plug or power cord is damaged or completely out of order;
- Problems with the power sensor.
Is the device plugged in?
Sometimes consumers complain that the cooler stopped heating water without connecting the equipment to the network. This reason is quite common among those who have just recently purchased equipment, and have not yet figured out the basics of its use.
Serviceability of the socket, plug and power cord
Damage to the outlet, power cord or plug. Sometimes, due to careless handling of the equipment, the power cord may fray, and as a result, the cooler will stop heating water. The same can be said about the plug with the socket. No need to exert excessive force when connecting the cooler to the network. In addition, it is not recommended to allow twisting of the wire, and its location in open space.
Sensor check
Each cooler is equipped with a special heating sensor located at the rear of the device. And if it fails, then the water in the tank simply ceases to heat up, and as a result there is a need for urgent repair of equipment.
Troubleshooting Methods
- In the first situation, the consumer only needs to connect the device to the electrical network, make sure that the corresponding lamp lights up, indicating the operability of the device and begin its operation.
- In case of problems with the plug, cord or socket, you will need to replace them, or if you have the appropriate knowledge, you can repair. It will be extremely simple, and will take no more than 10-15 minutes.
- But if the sensor breaks down, you will need to turn off the equipment and remove the back cover of the device. Then press the center button of the lower sensor until it clicks. If in this situation the equipment did not start to heat the water, you will need to contact the service center for repair by a professional specialist.
Leave Your Comment